Terracotta warrior (Eora3D laser scanner)

This 10cm high figurine of a terracotta warrior was scanned using the Eora3D laser scanner at low resolution. 8 scans were taken using the low resolution mode (1 million point per scan) on the supplied turntable. The resulting scans did not align in the Eora3D app, resulting with the usual 'tornado' effect (aligning the turnable is very difficult). So each scan was exported and registered using CloudCompare. As you can see from this mesh, it is far from perfect, but better than my last attempt. Source: Objaverse 1.0 / Sketchfab本件高10厘米的兵马俑陶俑（terracotta warrior）采用Eora3D激光扫描仪（Eora3D laser scanner）以低分辨率模式完成扫描。我们在配套旋转台（turntable）上以该低分辨率模式完成了8次扫描，单次扫描可生成100万个点云数据。 所得扫描数据无法在Eora3D应用中完成配准，出现了常见的“龙卷风”状异常效果（旋转台的配准难度极高）。因此我们将每一次扫描数据导出，并使用CloudCompare软件完成配准。 正如该网格模型所展示的，本次扫描结果远非完美，但相较于笔者此前的尝试已有提升。 数据集来源：Objaverse 1.0 / Sketchfab