The experimental and theoretical data on stretching of proteins.

denotes the experimentally measured value of as reported in the reference stated in the last column. denotes the experimental pulling speed used. is the value of the maximal force obtained in our simulation within the model. They were performed at . corresponds to the theoretical estimate of when extrapolated to the experimental speeds. The extrapolation assumes the approximate logarithmic dependence , where is . 10 speeds were used to determine the values of and in analogy to the procedure illustrated in Figure 11 The values of and are provided in columns 7 and 8 of the Table respectively. The first column indicates the corresponding symbol that is used in Figure 12.

**[原文缺失物理量]** 代表最后一列标注参考文献中报道的实验测量值。**[原文缺失物理量]** 代表本次实验所用的拉伸速率。**[原文缺失物理量]** 为我们在该模型框架内开展的数值模拟中得到的最大力数值。所有实验均于**[原文缺失实验条件，如温度、环境参数等]**下完成。**[原文缺失物理量]** 对应于将理论估算值外推至实验速率时的计算结果。该外推模型基于近似对数依赖关系，其中**[原文缺失参数]** 为**[原文缺失物理量或数值]**。本次研究共采用10组拉伸速率，参照图11所示的实验流程，确定**[原文缺失的两个参数]**的数值。**[原文缺失的两个参数]**的数值分别列于本表的第7列与第8列。第1列标注了图12中所使用的对应符号。