IMOS - SOOP-Sea Surface Temperature (SST) Sub-facility - 1-minute average data products

The Sea Surface Temperature (SST) sub-facility produces 1-minute average data products. Observed data are 1-minute median SST values and are retrieved from the vessel once an hour. High-resolution 1-minute median data are available in the delayed mode approximately every 3 months, these were produced in delayed mode using visual (manual) inspection of the quality flags after the data had been run through the automated quality control software at the Bureau of Meteorology The data products are produced from data from 3 ships: L'Astrolabe, Xutra Buhm and Wana Buhm, within this sub-facility working in the Australian region, Southern Ocean and South-East Asia. L'Astrolabe is a research vessel operating in Antarctic and sub-Antarctic waters during the summer period (usually October through March). 1-minute averaged SST (from the SBE 38 temperature sensor) and thermosalinograph salinity data are logged on the vessel and manually retrieved by CMAR staff after the voyage is completed. The data are run through the Bureau of Meteorology's automated quality control system followed by visual inspection and adjustment, if necessary, of the quality flags. This data stream is temporarily discontinued (2013). An SBE 48 hull-temperature sensor installed on both the MV Xutra Bhum and the MV Wana Buhm, produces observations of SST every 10 seconds. These data are recorded into 1 minute median SST values on the vessel and manually retrieved by Bureau of Meteorology staff approximately monthly. The data are run through the Bureau of Meteorology's automated quality control system followed by visual inspection and adjustment, if necessary, of the quality flags. Both of these data streams have now been discontinued (April 2013).

海表温度（Sea Surface Temperature, SST）子设施可产出1分钟平均数据产品。观测数据为1分钟中值海表温度值，每小时从作业船舶获取一次。高分辨率1分钟中值数据约每3个月以延迟模式发布，此类数据是经澳大利亚气象局（Bureau of Meteorology）的自动化质量控制软件处理数据后，通过目视（人工）检查质量标记，以延迟模式生成的。本子设施的数据产品来自3艘作业船舶：L'Astrolabe、Xutra Buhm与Wana Buhm，作业区域覆盖澳大利亚海域、南大洋及东南亚海域。
L'Astrolabe为研究船，夏季（通常为10月至次年3月）在南极及亚极带水域开展作业。其搭载的SBE 38温度传感器可采集1分钟平均海表温度数据，温盐计同步采集盐度数据，上述数据会在船舶上完成记录，并在航次结束后由CMAR工作人员人工取回。数据经澳大利亚气象局的自动化质量控制系统处理后，还会对质量标记进行目视检查与必要调整。该数据链路已于2013年临时中断。
MV Xutra Bhum与MV Wana Bhum两艘船舶均安装了SBE 48船体温度传感器，每10秒采集一次海表温度观测数据。这些数据会在船舶上整合为1分钟中值海表温度值，由澳大利亚气象局工作人员约每月人工取回一次。数据同样先经澳大利亚气象局的自动化质量控制系统处理，随后对质量标记进行目视检查与必要调整。上述两条数据链路均已于2013年4月正式中断。