2020 Contours, Town of Newark

The Rock County lidar project area covers approximately 771 square miles which includes a 100 meter buffer around the county boundary. The lidar data was acquired at a nominal point spacing (NPS) of 0.7 meters and a single swath nominal point density (NPD) of 2.0. Project specifications are based on Rock County requirements and on the U.S. Geological Survey National Geospatial Program LiDAR Base Specification, Version 2.1. The data was developed based on a horizontal projection/datum of NAD83(2011) / WISCRS Rock (ftUS) (EPSG Code: 7629), and vertical datum of NAVD88 - Geoid12B (Feet). LiDAR data was acquired using a Riegl VQ 1560i sensor with serial number 4040 from April 16, 2020 to April 26, 2020 in 5 total lifts. Acquisition occurred with leaves absent from deciduous trees, when no snow was present on the ground, and with rivers at or below normal levels.罗克县（Rock County）激光雷达（LiDAR）项目作业区总面积约771平方英里，包含县界周边100米的缓冲区。本次采集的激光雷达数据名义点间距（nominal point spacing, NPS）为0.7米，单条条带名义点密度（nominal point density, NPD）为2.0。本项目技术规范依据罗克县相关要求及美国地质调查局（U.S. Geological Survey）国家地理空间项目激光雷达基础规范2.1版制定。数据采用的水平投影基准为NAD83(2011) / WISCRS Rock (ftUS)（EPSG码：7629），垂直基准为NAVD88 - Geoid12B（英尺单位）。激光雷达数据采集使用序列号为4040的Riegl VQ 1560i传感器，采集时段为2020年4月16日至2020年4月26日，共计5次飞行架次。数据采集作业在落叶乔木无叶、地面无积雪且河流水位处于正常或低于正常水位的条件下进行。