Processed Data for: Active deformation in Ecuador enlightened by a new waveform-based catalog of earthquake focal mechanisms

Description of the file “res_inv_parameter.xls”, providing access to the seismic source parameters determined by the MECAVEL method.
Column A: earthquake identifier using its date in the given format. Columns B-E (“la_0”, “lo_0”, “pf_0”, “mg_0”) refer to the initial latitude, longitude, depth and magnitude, respectively (latitude and longitude in degrees, depth in km). These parameters come from the IG-EPN catalog and are used as starting parameters for the MECAVEL inversion. Columns F-I (“la_i”, “lo_i”, “pf_i”, “mg_i”) refer to the inverted latitude, longitude, depth and moment magnitude, respectively (latitude and longitude in degrees, depth in km). Columns J-O describe the MECAVEL inverted focal mechanism: “az1”, “dp1” and “rk1” are the strike, dip and rake, respectively, of one of the nodal planes; “az2”, “dp2”, “rk2” are the strike, dip and rake, respectively, of the other nodal plane. All these angles are given in degrees. Column P (“msft”) is the mean misfit between observed and synthetic waveforms. Column Q-S (“NchZ”, “NchN”, “NchE”) are the number of vertical, North-South and East-West channels, respectively, used in the inversion. Column T (“st_tot”) is the total number of stations used and column U (“gap”) is the maximum azimuthal gap in degrees. Column V (“Qlt”) is the quality criteria derived for each solution (based on misfit, number of used waveforms and azimuthal gap): quality A refers to the most reliable solutions, followed by B and C.

文件“res_inv_parameter.xls”的描述，该文件提供了由MECAVEL方法确定的地震源参数。列A：使用给定格式的日期标识地震。列B-E（“la_0”、“lo_0”、“pf_0”、“mg_0”）分别代表初始纬度、经度、深度和震级（纬度和经度以度为单位，深度以千米为单位）。这些参数来源于IG-EPN目录，并作为MECAVEL反演的起始参数。列F-I（“la_i”、“lo_i”、“pf_i”、“mg_i”）分别代表反演得到的纬度、经度、深度和矩震级。列J-O描述了MECAVEL反演得到的节面机制：“az1”、“dp1”和“rk1”分别代表一个节面的走向、倾角和滑动方向；“az2”、“dp2”、“rk2”分别代表另一个节面的走向、倾角和滑动方向。所有这些角度均以度为单位。列P（“msft”）是观测波形与合成波形之间的平均拟合度。列Q-S（“NchZ”、“NchN”、“NchE”）分别代表用于反演的垂直、南北和东西方向的通道数量。列T（“st_tot”）代表使用的总台站数，列U（“gap”）代表最大方位角间隙（以度为单位）。列V（“Qlt”）为每个解推导出的质量标准（基于拟合度、使用的波形数量和方位角间隙）：质量A代表最可靠的解，其次是B和C。