Chromatin Accessibility Data Sets Show Bias Due to Sequence Specificity of the DNase I Enzyme

BackgroundDNase I is an enzyme which cuts duplex DNA at a rate that depends strongly upon its chromatin environment. In combination with high-throughput sequencing (HTS) technology, it can be used to infer genome-wide landscapes of open chromatin regions. Using this technology, systematic identification of hundreds of thousands of DNase I hypersensitive sites (DHS) per cell type has been possible, and this in turn has helped to precisely delineate genomic regulatory compartments. However, to date there has been relatively little investigation into possible biases affecting this data.ResultsWe report a significant degree of sequence preference spanning sites cut by DNase I in a number of published data sets. The two major protocols in current use each show a different pattern, but for a given protocol the pattern of sequence specificity seems to be quite consistent. The patterns are substantially different from biases seen in other types of HTS data sets, and in some cases the most constrained position lies outside the sequenced fragment, implying that this constraint must relate to the digestion process rather than events occurring during library preparation or sequencing.ConclusionsDNase I is a sequence-specific enzyme, with a specificity that may depend on experimental conditions. This sequence specificity is not taken into account by existing pipelines for identifying open chromatin regions. Care must be taken when interpreting DNase I results, especially when looking at the precise locations of the reads. Future studies may be able to improve the sensitivity and precision of chromatin state measurement by compensating for sequence bias.