Carbon Capture and Storage through Upcycling of Suberinic Acid Residues in Wood Composites Finishing

In this research, an attempt to create coatings in the form of a film by combining a biopolymer with suberinic acid residues (SARs) was made. Two types of biopolymers were used, polylactide (PLA) and polycaprolactone (PCL), in various polymer-SAR ratios. Suberinic acid as a residue is a raw material that can potentially contribute positively to the fixing of CO2 from the atmosphere, which creates the possibility for further use. As part of this study, the obtained coatings were tested in terms of scratch resistance, relative hardness, cold liquids, total volatile organic compounds (TVOCs), formaldehyde emission, surface absorption, etc. Differences between the polymers used and the effect of the SAR additive on selected surface properties were demonstrated. The addition of carbon-rich SAR significantly improves the gas barrier properties of the PLA- and PCL-based surface finishing materials. The relative hardness and scratch resistance also increased with rising SAR content. However, the increasing content of SAR filler acts as a limiter in the depth of penetration of the deposited surface finishing materials onto the wood surface. It is possible to state that this innovative approach regarding (1) the utilization of biopolymers as a matrix, instead of conventional, crude oil-based resins, and (2) the incorporation of post-processed carbon-rich waste lignocellulosic materials to produce the surface finishing and/or protective films has been confirmed.