five

PSP FIELDS Digital Fields Board (DFB) AC-coupled Searchcoil Magnetometer, SCM, Cross Spectra, d-component, f-component, High Gain, Sensor coordinates, Level 2 (L2), 0.873813 s Data

收藏
DataCite Commons2025-12-29 更新2025-04-16 收录
下载链接:
https://spase-metadata.org/NASA/NumericalData/ParkerSolarProbe/FIELDS/DFB/Level2/AC/CrossSpectra/SCM/D-F/LowFrequency/HighGain/PT0.873813S
下载链接
链接失效反馈
官方服务:
资源简介:
PSP FIELDS Digital Fields Board (DFB), XXX ⨯ YYY cross spectra data: The DFB is the low frequency, less than 75 kHz, component of the FIELDS experiment on the Parker Solar Probe spacecraft, see reference [1] below. For a full description of the FIELDS experiment, see reference [2]. For a description of the DFB, see reference [3]. DFB AC cross spectra data for a pair of input channels consist of: * 1) Power spectral densities (auto spectra, e.g. FT₁ ⨯ FT₁*) * 2) Real and imaginary parts of the spectral cross term (FT₁ ⨯ FT₂*) * 3) Coherence * 4) Phase where all as a function of frequency and time. The last two terms are describedcoherence and phase are defined in [3]. These cross spectra are averaged in both frequency and time as described in [3]. The cross spectra have either 56 or 96 bins (selectable) with the bin central frequencies reported in the metadata. The AC cross spectra are duty-cycled such that spectral averaging takes place over the first 1/8 of any given NYs (assuming a 1 NYs data cadence). Less data are averaged by 2^N for cadences faster than 1 NYs by 2^N. For cadences slower than 1 NYs, the first 1/8 of each NYs of data included are averaged together to form the reported data. The Level 2 data products contained in this data file have been calibrated for: * 1) The Hanning window used in the spectral calculation * 2) DFB in-band gain * 3) DFB analog filter gain response * 4) DFB digital filter gain response * 5) The search coil preamplifier response, when applicable * 6) The bandwidth of each spectral bin Note that compensation for the DFB digital filters will introduce a non-physical positively sloped power trend at high frequencies when the non-corrected signal is dominated by noise. This effect should be examined carefully when determining spectral slopes and features at the highest frequencies. Calibrations for the FIELDS preamplifiers have not been implemented as the preamplifier response is flat and equal to one through the DFB frequency range. Corrections for plasma sheath impedance gain and antenna effective length have not been applied to voltage sensor signals. These corrections will be applied in the Level 3 DFB data products. Therefore, all voltage sensor quantities when present in these Level 2 data products are expressed by using units of Volts squared per Hertz. Likewise, all magnetic field quantities when present in these Level 2 data product are expressed by using units of nanoTesla squared per Hertz. The units for phase are degrees. The Level 2 voltage data products contained in this data file are expressed in sensor coordinates: e.g. dV12, dV34 for voltage measurements. For solar orbits 1 and 2, the search coil magnetometer cross spectra data are rotated into a non-intuitive coordinate system with components [d,e,f]. For solar orbits 3 and beyond, the magnetic field cross spectra data are expressed by using search coil magnetometer sensor coordinates with components [u,v,w]. To rotate from [d,e,f] coordinates to [u,v,w] search coil sensor coordinates, use the following matrix, written in IDL notation, and the following equation: spectra_uvw_vector = R ## spectra_def_vector. R = [[ 0.46834856, -0.81336422 , 0.34509170] [ -0.66921924, -0.071546954, 0.73961249] [ -0.57688408, -0.57733845 , -0.57782790]] For some orbits, sufficient spectral information exists in the auto spectra and cross spectra to determine wave ellipticity, planarity, and wave normal angles. One method for accomplishing this is presented in reference [4]. Time resolution of the DFB AC cross spectral data can vary by multiples of 2^N. During encounter (when PSP is within 0.25 AU of the Sun), cadence for the DFB AC cross spectra is typically 1 NYsecond [2]. Timestamps correspond to the center time of each window. References: * 1) Fox, N.J., Velli, M.C., Bale, S.D. et al., Space Sci Rev (2016) 204:7. https://doi.org/10.1007/s1121401502116 * 2) Bale, S.D., Goetz, K., Harvey, P.R. et al., Space Sci Rev (2016) 204:49. https://doi.org/10.1007/s1121401602445 * 3) Malaspina, D.M., Ergun, R.E., Bolton, M. et al., JGR Space Physics (2016), 121, 5088-5096. https://doi.org/10.1002/2016JA022344 * 4) Santolik, O., Parrot, M., Lefeuvre, F. Radio Science (2003), 38, 1010. https://doi.org/10.1029/2000RS002523
提供机构:
Space Physics Data Facility
创建时间:
2021-04-28
二维码
社区交流群
二维码
科研交流群
商业服务