Data of "A consistent finite-strain thermomechanical quasi-nonlinear-viscoelastic viscoplastic constitutive model for thermoplastic polymers"

Id: Data of following publication "Ujwal Kishore Jinaga,, Kepa Zulueta, Aizeti Burgoa, Lucia Cobian, Ubiratan Freitas, Michael Lackner, Zoltan Major, Ludovic Noels, A consistent finite-strain thermomechanical quasi-nonlinear-viscoelastic viscoplastic constitutive model for thermoplastic polymers, International Journal of Solids and Structures 321 (2025) 113517, 10.1016/j.ijsolstr.2025.113517" Data doi on 10.5281/zenodo.15370425 Carbobrake This research has been funded by the Walloon Region under the agreement no. 2010092-CARBOBRAKE in the context of the M-ERA.Net Join Call 2020. Funded by the European Union under the Grant Agreement no. 958174. Views and opinions expressed are those of the author(s) only and do not necessarily reflect those of the European Union or the European Commission. Neither the European Union nor the granting authority can be held responsible for them. MOAMMM TPU experimental results were obtained in MOAMMM project which has received funding from the H2020-EU.1.2.1.-FET Open Programme project MOAMMM under grant No 862015. Views and opinions expressed are those of the author(s) only and do not necessarily reflect those of the European Union or the European Commission. Neither the European Union nor the granting authority can be held responsible for them. License Licensed under the Creative Commons Attribution 4.0 International (CC BY 4.0) (https://creativecommons.org/licenses/by/4.0). Directories This directory contains 3 Folders with several subfolders: Calibration Split into two subfolders by material type. Each folder has the following: python3 "Polypropylene/TPU"_Experiments_monotonic_cyclic.py - Run to generate requisite experimental plots and their pdfs. loadCase_ParaValues_"PP/TPU"_cube.py - Library of parameter values (No output). runCaseScript_"PP/TPU"_cube.py - This is base input file fully parametrised (No output). python3 runScript_"PP/TPU"_cube.py - MAIN file to run and generate "dat" files and folders with the calibration results. Creates "dat" binary files for deformation (F)/ material parameters (M)/ stress (P)/ temperature (T)/ equivalent plastic strain (epl)/ loadcase (L) Also, Creates folders for each case to postproc in gmsh if required.) python3 makePlots.py - Run to generate the calibration exp. vs num. plots and their pdfs based on existing results. The other files if any include data for cyclic loading. Experiments The requisite experimental data for calibration and validation on PP BJ380MO by Leartiker and TPU EOS 1301 by IMDEA/JKU Several subfolders - split first on material type and then the last folder contains a readMe.txt to explain the experiment files. THIS FOLDER HAS NO PLOTS, only data. USE python3 "...Experiments..." .py in the other folder to generate these plots. Validation - All validation tests for TPU split by test type and simulation numbers as follows in respective folders: Compression - Uses TPU tests - A_viii, A_ix, A_x, A_xi Tension - Uses TPU tests - A_iii, A_iv, A_v, A_vi Torsion - F22, F23, F24 with axial displacement constraint, F25, F26, F27 without axial displacement constraint TorsionRotationCorrection - F26 (w/o correction), F43 (with correction) Images_Paper1 - Has the generated figures Run to generate the validation exp. vs num. plots and their pdfs based on existing results: python3 validationPlots.py