Pore water data of sediment incubation experiments under anoxic conditions

Enhanced mineral dissolution in the benthic environment is currently discussed as a potential technique for ocean alkalinity enhancement (OAE) to reduce atmospheric carbon dioxide (CO2) levels. This study explores how biogeochemical processes affect the dissolution of alkaline minerals in surface sediments during laboratory incubation experiments. These involved introducing dunite and calcite to organic-rich sediments from the Baltic Sea under controlled conditions in an anoxic to hypoxic environment. The sediment cores were incubated with Baltic Sea bottom water. Eight sediment cores were positioned vertically in a rack. Since the sediment surface was slightly oxidized by the bottom water (∼125 μmol l−1 upon recovery), the cores were left plugged on the top for 13 days to settle after recovery until the sediment surface was anoxic. To achieve chemical conditions that are expected in the natural system, 500l of retrieved sea water were degassed via bubbling with pure dinitrogen gas in batches of 100 l. Afterwards, between 50 and 60 l were transferred into an evacuated gas tight bag. After the transfer, pH and total alkalinity (TA) were measured to determine the dissolved inorganic carbon (DIC) of the water. Afterwards the DIC was increased via adding pure CO2 until a CO2 partial pressure (pCO2 ) of ∼2,300–∼3,300 μatm was established mimicking conditions prevailing in Boknis Eck during summer. Stirring heads were installed on the cores. To prevent the development of oxic conditions, it was ensured that as little gas phase as possible was left in the cores. Elimination of pelagic autotrophs, heterotrophs, and suspended particles was achieved by flushing the cores with modified bottom water for 2 days with a flow rate of 1.5 mml min−1. Afterwards, a continuous throughflow of 700 μl min−1 from the reservoir of modified bottom water was applied, leading to a residence time of ∼2.1 days inside the cores. For the experimental incubations, six cores received additions of alkaline materials, three with calcite (Cal1 - Cal3) and three cores with dunite (Dun1 - Dun3), leading to three replicates per treatment. Two control cores remained untreated (C1, C2). The amount of added substrate was based on the rain rate of particulate organic carbon observed in Boknis Eck (0.5 mmol cm−2 a−). The incubation lasted for 25 days. […]