Additional file 7 of Floral infrared emissivity estimates using simple tools

Additional file 7. Water bath estimation extracted data. The full data extracted from thermal images and the emissivity estimates from the water bath protocol. Column headings are as follows: ‘measurement’ a name identifier for each flower measurement. ‘individual within species’ the numerical identifier of individual flowers within each species numbers are shared across species, this is used for flower identification not for analysis. ‘Individual’ numerical identifier of flower individual across all species. ‘species’ the flower species. ‘measurement location’ the measurement location, here reproductive structures are indicated as ‘A: repro struc’, petal base as ‘B: petal base’, petal edge as ‘C: petal edge’. ‘Set temperature of waterbath’ the temperature to which the water bath was set to, written as ‘[temp]C’ to insure it is read as a categorical factor by R. ‘thermometer temp of waterbath’ the temperature of the water bath measured by the thermometer in degrees Celsius. ‘Tref’ the reflected temperature at the measurement indicated by previous columns. ‘IRT temp of waterbath e = 0.98, d = 0.5, rest asp per image’ the water temperature proximal to the flower as measured by the thermal camera, used to obtain Tobj. ‘at e = 1 d = 0, Temp uncorrected (for W)’ the apparent temperature at measurement indicated by the previous columns. ‘at e = 0.98 d = 0.5’ the camera’s temperature measurement, in kelvin, when emissivity was 0.98 at the measurement indicated by the previous columns. ‘DeltaTobj-T0.98’ the ‘Tobj (k)’ measurement minus that of the thermal camera when emissivity was 0.98 (‘at e = 0.98 d = 0.5’). ‘Ecal’ and ‘Esolve’ the calculated and Solver emissivity estimates respectively at the measurement indicated by the previous columns. ‘DeltaE’ the difference between calculated and Solver emissivity estimates at measurement indicated by the previous columns.