Dataset S1

This dataset was used for the paper: "Forests are chill: The interplay between thermal comfort and mental wellbeing", published in Lanscape and Urban Planning (2023). Full methodological details are found in the paper and its appendix.Here follows the column description:<b>vp_code </b>= Participant code.<b>Site </b>= One of three peri-urban forest sites.<b>PlotID </b>= The forest (i.e. low, medium or high biodiversity level) or non-forest (i.e. control = non-forest baseline control, urban = urban control) conditions.<b>Intervention </b>= Before or after the forest or urban intervention. All participants started at the non-forest baseline (i.e. 'pre') and were then randomly assigned to one of four conditions (i.e. 'post')<b>TC_1 </b>to <b>TC_10 </b>= Respectively, Thermal Sensation Vote, Humidity Sensation Vote, Wind Sensation Vote, Sun Sensation Vote, Thermal Preference Vote, Humidity Preference Vote, Wind Preference Vote, Sun Preference Vote, Most Unpleasant Condition Vote, Overall Comfort Vote.<b>TC_clo_head </b>to<b> TC_clo_foot</b> = The clothing and fabric participants were wearing (self-reported).<b>QuestionnaireTime</b> = Time when participants filled in the questionnaire related to thermal comfort. <b>AirT</b> = Air temperature at the time of filling in the thermal comfort questionnaire.<b>TmrtThorsson</b> = Mean radiant temperature, following calculations as in Thorsson et al. (2007), at the time of filling in the thermal comfort questionnaire.<b>PET </b>= Physiologically Equivalent Temperature at the time of filling in the thermal comfort questionnaire.<b>mPET </b>= Modified Physiologically Equivalent Temperature at the time of filling in the thermal comfort questionnaire.<b>PETroll </b>= Physiologically Equivalent Temperature at the time of filling in the thermal comfort questionnaire, with a 10-min left-aligned rolling average to correct for the thermal conditions experienced in the period before the questionnaire was filled in.<b>mPETroll </b>= Modified Physiologically Equivalent Temperature at the time of filling in the thermal comfort questionnaire, with a 10-min left-aligned rolling average to correct for the thermal conditions experienced in the period before the questionnaire was filled in.<b>BAplot</b>= Basal area of forest plots only.<b>ShannonBAScaled</b> = Shannon diversity based on the species-specific proportions in terms of basal area within the plot. Only for forests. <b>ShannonCovScaled</b> = Shannon diversity based on the species-specific proportions in terms of crown cover within the plot. Only for forests. <b>Hplot</b> = Average height of the dominant trees. Only for forests.<b>CCperc</b> = Canopy cover of the plot, in percent, based on hemispherical photographs. Forest forests, but also for non-forest conditions. The latter corresponds then to the share of obscured sky. <b>AI_total</b> = Authenticity index.Note that the mental wellbeing parameters are not added to this dataset. They should be found in the related paper by Rozario et al. (2023) in People and Nature.本数据集配套发表于2023年《景观与城市规划（Landscape and Urban Planning）》的论文《森林之益：热舒适与心理福祉的交互作用（Forests are chill: The interplay between thermal comfort and mental wellbeing）》。完整方法学细节请参见该论文及其附录。以下为各字段说明:<b>vp_code </b>= 参与者编码。<b>Site </b>= 三个城郊森林样地之一。<b>PlotID </b>= 样地类型，涵盖森林（即低、中、高生物多样性水平）或非森林（即对照组=非森林基准对照，城市组=城市对照）两种条件。<b>Intervention </b>= 森林或城市干预的前/后阶段。所有参与者均以非森林基准状态（即"干预前"）为起始，随后被随机分配至四种干预条件之一（即"干预后"）。<b>TC_1 </b>至<b>TC_10 </b>= 依次为热感觉投票、湿度感觉投票、风力感觉投票、日照感觉投票、热偏好投票、湿度偏好投票、风力偏好投票、日照偏好投票、最不适环境投票、整体舒适投票。<b>TC_clo_head </b>至<b>TC_clo_foot</b> = 参与者自述的头部至足部所穿衣物及面料信息。<b>QuestionnaireTime</b> = 参与者填写热舒适相关问卷的时间。<b>AirT</b> = 填写热舒适问卷时的空气温度。<b>TmrtThorsson</b> = 平均辐射温度，计算方法遵循Thorsson等人（2007）的研究，为填写热舒适问卷时的实测值。<b>PET </b>= 生理等效温度（Physiologically Equivalent Temperature），为填写热舒适问卷时的数值。<b>mPET </b>= 修正生理等效温度（Modified Physiologically Equivalent Temperature），为填写热舒适问卷时的数值。<b>PETroll </b>= 填写热舒适问卷时的生理等效温度，采用10分钟左对齐滚动平均法以校正问卷填写前时段内经历的热环境条件。<b>mPETroll </b>= 填写热舒适问卷时的修正生理等效温度，采用10分钟左对齐滚动平均法以校正问卷填写前时段内经历的热环境条件。<b>BAplot</b>= 仅适用于森林样地的断面积。<b>ShannonBAScaled</b> = 基于样地内各树种断面积占比计算的香农多样性指数，仅适用于森林样地。<b>ShannonCovScaled</b> = 基于样地内各树种冠层覆盖占比计算的香农多样性指数，仅适用于森林样地。<b>Hplot</b> = 优势树种的平均树高，仅适用于森林样地。<b>CCperc</b> = 基于半球摄影法测得的样地冠层覆盖百分比，适用于森林及非森林样地；对于非森林样地，该值对应被遮挡天空的占比。<b>AI_total</b> = 真实性指数（Authenticity index）。请注意，本数据集未包含心理福祉相关参数，相关参数请参见Rozario等人（2023）发表于《人类与自然（People and Nature）》的相关论文。