Brick Layering Experiment

Document OverviewThis document presents all data extracted from the Brick Layering strategy experiment conducted for the 22nd ICMR paper titled "Evaluating the Effectiveness of Brick Layering in FDM 3D Printing: A Parameterized Study on Tensile Properties of PLA." The content is organized into four main tabs, described as follows:1. OverviewThis tab provides a summary table containing the processing parameters and average results for all tested configurations, offering a general overview of the experiment. It also includes six comparative plots covering Ultimate Tensile Strength (UTS), Maximum Strain, Young’s Modulus, Weight, Cross-Sectional Area (CSA), and Weight vs. Area.2. Experiment ResultsThis tab contains the raw and calculated data for each specimen, including dimensional measurements, mechanical test outputs, and post-processing calculations. Reference values—52mm² for theoretical area and 11.09 g for weight (based on a material density of 1.23g/cm³)—were used to evaluate dimensional accuracy and material deposition.3. Stress vs. Strain PlotsThis section presents 12 stress–strain graphs, each corresponding to a specific configuration and showing all sample plots grouped accordingly.4. ANOVA & T-TestThis tab reports the statistical analysis results, including independent two-sample t-tests and one-way ANOVA, to determine the significance of variations in mechanical properties across configurations.