RO-X-RPCMAG-2-CR5-RAW

Data Set Overview The data from the ROSETTA PLASMA CONSORTIUM (RPC) Fluxgate Magnetometer(MAG)was submitted by Ingo Richter (TM) for the RPCMAG team. The PI of the team is KarlHeinz Glassmeier. The data have been measured during the CRUISE 5 phase between February 24, 2010 and April 27, 2010. Included are the data of the following events: June 24, 2010 RPC was switched to monitor the Lander Panel Test March 14 March 15, 2010 RPCMAG was switched on for the LUTETIA flyby Rehearsal. We intended to get a reference measurement for comparison with the data of the real flyby in June 2010. Unfortunately the rehearsal conditions diverged significantly from those at the very flyby. Thus these data could not be used as a good reference model. April 27, 2010 This was the Payload Checkout #12 (PC12). All magnetic field data are edited raw data. That means the data represent the 3 components of the magnetic field measured in counts of the used 20 bit ADC. Data are given in instrument coordinates. Neither any filtering nor any calibration has been applied to the data. Any s/c generated noise and s/c caused residual magnetic fields are not eliminated. The data are sorted by the sensor (OB: outboard sensor, IB: inboard sensor)and the measurement mode (M1..M6). They can uniquely be identified by their file names. Normally the OB is the Primary (Pri) and the IB is the Secondary (Sec) sensor. However, this order can be toggled by TCs. This feature has been tested especially during the commissioning phases. In cases where the PRIMARY and SECONDARY sensor were toggled the individual data files (OB/IB) will contain data measured with different sampling rates according to the actual sampling rates of the PRIMARY and SECONDARY sensors. Refer to the MODE DESCRIPTION table below. The actual sampling rate is the only indicator showing which sensor is the primary and which is the secondary one. REMARK: Due to stron truncated!, Please see actua [truncated!, Please see actual data for full text]