RL-CAL-SD2-3-GRND

Data Set Overview This data set contains the data referred to the GRM tests performed for the entire mission. There are data acquired in 2002 used for prelaunch instrument testing and calibration. There are later data taken in 2012 during commissioning and data taken during First Science Sequence (FSS) in 2014. During FSS, all the tests were aimed at verifying the mission plans (list of commands) prepared for the activities requested to SD2 during the FSS phase prior to their onboard execution. Data Both data, scientific and housekeeping, are collected in this data set. They refers to CODMAC Level 3. Note that the Volume Checker was not used during FSS activities. The decision of not using it was based on one main concern: due to the possible presence of ice, the sample could have remained attached to the Volume Checker and, then, removed from the oven during the sample discharging operation. The fact that the Volume Checker was not used is evident from the columns associated to the Volume Checker displacement in the calibrated data, which report the number 9999.99. The list of activities requested to SD2 and tested on the GRM for the FSS phase follows: First sampling: offset 530 mm, sample in Oven #19 (HTO) to PTOLEMY 1. Rearming oven under drill 2. 15 mm downward and upward drill translation for drill bit rearming 3. Hole under drill 4. Drilling to 530 mm 5. Sample retrieval 6. Oven #19 under drill 7. 10 mm downward and upward drill translation for sample release 8. Oven #19 under PTOLEMY Second sampling: offset 560 mm, sample in Oven #17 (HTO) to COSAC 1. Rearming oven under drill 2. 15 mm downward and upward drill translation for drill bit rearming 3. Hole under drill 4. Drilling to 560 mm 5. Sample retrieval 6. Oven #17 under drill 7. 10 mm downward and upward drill translation for sample release 8. Oven #17 under COSAC Third sampling: offset 590 mm, sample in Oven #3 (MTO) to CIVA/COSAC truncated!, Please se [truncated!, Please see actual data for full text]