Electronic Data relating to “A comparative study of the modal response of additively and subtractively manufactured thin plates after thermal loading ” By M. Weihrauch, P. Lambert, J. Lambros, C. J. Sutcliffe, E. A. Patterson

Static, thermal, and displacement data files used to produce the results presented in “A comparative study of the modal response of additively and subtractively manufactured thin plates after thermal loading ”.
The included data shows:
1) Full field temperature data collected with a microbolometer during the heating and cooling of specimens. Temperature was recorded for 6 minutes of heating and 24 minutes of subsequent cooling after quartz lamps were turned off. Temperature data was collected for half an hour at two seconds intervals.
2) Z-Displacement data with rigid body motion removed of specimens, which were collected during the heating and cooling of specimens via digital image correlation (DIC). Data were collected for a total of half an hour at four second intervals.
3) Static distance to a plane data collected via digital image correlation for all specimens before and after heat cycling.
4) The first 6 modal shapes captured via digital image correlation of all specimens before and after heating.

The following folders are included:
1) Heat Cycling data: Z-RBMR data for approximately 6 minutes of heating and 24 minutes of cooling for all three test specimens contained in the "Z-RBMR Data" subfolder. Full-field temperature data for the same heating cooling cycle shown in "Z-RBMR Data" for each specimen can be found in the "Temperature Data" sub-folder.
2) Distance From a plane: Distance to plane pre- and post heating for all tested specimens can be found in this folder
3)Modal Shapes: The first 6 modal shapes pre- and post- heating for each of the tested specimens

本数据集包含了用于生成《添加制造与减材制造薄板在热载荷下的模态响应比较研究》一文中呈现结果的静态、热学以及位移数据文件。其中所包含的数据包括：
1) 使用微测辐射热计在加热和冷却过程中收集的完整场温度数据。温度记录了关闭石英灯后的6分钟加热及随后的24分钟冷却过程，温度数据以每两秒一次的间隔收集了半小时。
2) 通过数字图像相关技术（DIC）在加热和冷却过程中收集的去除刚体运动的Z向位移数据。数据以每四秒一次的间隔收集了半小时。
3) 通过数字图像相关技术在所有试样热循环前后收集的静态距离至平面数据。
4) 通过数字图像相关技术在所有试样加热前后捕捉的前6个模态形状。
所包含的文件夹如下：
1) 热循环数据：包含“Z-RBMR数据”子文件夹中的所有三个测试试样的大约6分钟加热和24分钟冷却的Z-RBMR数据。每个试样的相同加热冷却周期的全场温度数据可在“温度数据”子文件夹中找到。
2) 距离至平面：包含所有测试试样在加热前后的距离至平面数据。
3) 模态形状：包含所有测试试样加热前后的前6个模态形状。