PAPERMAKING WASTE SLUDGE FIBER-CEMENT COMPOSITE PANEL: STABILIZATION AND SOLIDIFICATION OF HIGH FE AND TI CONTENT-PETROCHEMICAL ASH

ABSTRACT In this study, the effect of papermaking waste sludge (PWS), petrochemical ash, and metakaolin (MK) replacement with portland cement in the manufacturing of fiber-cement composite (FCC) was investigated. Moreover, the toxicity of materials and FCC was evaluated. Modulus of rupture (MOR), (MOE), fracture toughness (FT), internal bonding strength (IB), water absorption after 24h immersion in water (WA24), and density of FCCs were measured. X-ray diffraction patterns were also obtained. According to the main results, Composites produced with 6% PWS content showed superior mechanical properties. Higher contents of PWS resulted in the reduction in fiber-matrix interfacial adhesion, increasing void contents, and hence lower strength properties. Replacing petrochemical ash and MK up to 10% provided optimum combinations and lightweight composites. In addition, X-ray diffraction patterns confirmed pozzolanic reactions of materials. Toxicity investigation showed that concentration of heavy metals in FCC leachate were reduced compared with ash. Pozzolanic reaction of materials had positive influence on solidification and stabilization of heavy metals. In conclusion, FCCs with the highest pozzolanic activity, were considered as the optimum combination. Moreover, successful stabilization and solidification of heavy metals occurred. Therefore, not only PWS and petrochemical ash can be reused in FCC manufacturing, but they also in turn reduced environmental pollution.