Statistical analysis of the design procedure used in reinforced concrete pipes

Abstract Structural design procedures are based on simplified hypotheses that attempt to approximate the actual behaviour. Depending on the adopted hypothesis, the design procedure may not satisfactorily describe the structural actual behaviour. Such condition occurs in the design of reinforced concrete pipes, where there are uncertainties related especially on the internal forces and the installation type of the pipe. Moreover, the main design hypothesis is that the cross section is plane and perpendicular to the deformed axis. Based on materials resistance principles it is known that this hypothesis is unsatisfactory to pipes with aspect ratio lower than ten. Note that the commercial reinforced concrete pipes usually present aspect ratio well below ten. In the light of the foregoing, the main objective of this paper is to analyse the accuracy of the design procedure for reinforced concrete pipes. Therefore, statistical processes were used to compare design values with experimental results. The comparisons in this paper showed that the design procedure results in oversized pipes.