Cell-to-Cell-Variations of a Panasonic NCR18650B

<strong>Cell-to-Cell-Variations of Panasonic NCR18650B </strong> This dataset contains raw characterization data from 92 Panasonic NCR-18650B cells at the beginn of life. Information on the measurements performed can be taken in part from this readme file. Further details can be found in doi:\\ . Pulse measurements, pseudo-open circuit measurements, and impedance measurements are recorded. All measurements are performed in a Binder MK 155 climate chamber at 25°C. <strong>Pseudo Open Circuit Voltage</strong> POCV is recorded with a constant current of 0.05C in the charge and discharge direction. The measurements are performed with an Arbin LBT 5V-25A cell tester. The data is stored as a Matlab struct containing the following entries: <pre><code class="language-markdown">pocv.ch % POCV of during charging pocv.dc % POCV of during discharging pocv.soc % SoC of the pocv curves</code></pre> The POCVs are interpolated to 5000 equidistant SOC points and sorted in the direction of the SOC vector. <strong>Impedance</strong> Impedance measurements are at 50% SOC(actual measured discharge C/20 capacity as reference) after 4h of relaxation. The measurements are conducted with a Zahner Zenium Pro spectroscope with an amplitude of 250 mA in a frequency range between 0.01 Hz and 10 kHz with 10 steps per decade. The data is stored as a Matlab struct containing the following entries: <pre><code class="language-markdown">impedance.f % Frequency in Hz impedance.Z_imag % Imaginary Part of the impedance in Ohm impedance.Z_real % Real part of the impedance in Ohm impedance.Z % Complex valued impedance in Ohm</code></pre> Each row corresponds to a dataset of an individual cell and each column corresponds to a measurement frequency. The same applies to the .csv files. <strong>Pulse Test</strong> Pulse measurements are performed at 50% SOC (actual measured discharge C/20 capacity as reference) after 2h of relaxation. The measurements are performed with an Arbin LBT 5V-25A cell tester. The pulse test is performed with a current of 0.5C for 10s followed by a relaxation of 30 minutes. The discharge pulse follows the charge pulse. The data is stored as a Matlab struct containing the following entries: <pre><code class="language-markdown">pulse.neg_time % Time of the discharge pulse sequence pulse.neg_voltage % Voltage of the discharge pulse sequence pulse.pos_time % Time of the charge pulse sequence pulse.pos_voltage % Voltage of the charge pulse sequence </code></pre>