Replication Data for: Computer-aided method for rotary crane stability assessment

This repository contains data obtained during the preparation of the article entitled Computer-aided method for rotary crane stability assessment. In this article, a method for determining the stability of a truck crane was proposed using SolidWorks software. The terminology temporary loss of stability was also proposed. The repository contains two files from performed research: experimental and numerical. The article analyzed two cases of crane movement - overlapping and non-overlapping kinematic excitations. They are marked as \"over\" and \"noover\" respectively in the files. In addition, three load masses that the crane can carry were analyzed: 10 kg, 22.5 kg and 40 kg. The files used the notation \"m10\" corresponding to a mass of 10 kg, \"m22.5\" corresponding to 22.5 kg and \"m40\" corresponding to 40 kg.本数据集仓库包含了题为《Computer-aided method for rotary crane stability assessment》（回转起重机稳定性评估的计算机辅助方法）的学术论文筹备阶段所获取的全部数据。本文提出了一种基于SolidWorks软件的汽车起重机（truck crane）稳定性判定方法，同时首次提出了“暂态失稳（temporary loss of stability）”这一专业术语。本仓库包含本次研究生成的两类文件：实验数据文件与数值仿真数据文件。论文分析了起重机运动的两种工况——运动激励叠加与非叠加运动激励，两类工况在数据文件中分别以“over”与“noover”作为标识。此外，研究还覆盖了起重机可承载的三种载荷质量：10 kg、22.5 kg与40 kg，数据文件中分别以“m10”（对应10 kg载荷）、“m22.5”（对应22.5 kg载荷）及“m40”（对应40 kg载荷）进行标注。