Boyagin FLUXNET Release 2025_r1

This release consists of flux tower measurements of the exchange of energy and mass between the surface and the atmospheric boundary-layer using eddy covariance techniques. Data were processed using PyFluxPro (v3.4.21) as described by Isaac et al. (2017) for the quality control and post-processing steps. The final, gap-filled product containing Net Ecosystem Exchange (NEE) partitioned into Gross Primary Productivity (GPP) and Ecosystem Respiration (ER) has been produced using the ONEFlux software as described in Pastorello et al (2020). This data set has been produced as part of the FLUXNET Shuttle project. The Boyagin Wandoo Woodland flux station is located approximately 12km west of Pingelly, near Perth, Western Australia. It was established in September 2017 and is managed by the University of Western Australia. The flux tower site is located within an area of wandoo woodland. The surrounding area is dominated by broadacre farming practices. Elevation of the site is close to 484m and mean annual precipitation at a nearby Bureau of Meteorology site at Pingelly measures 446mm. Maximum temperatures range from 15.3°C (in July) to 31.9°C (in Jan), while minimum temperatures range from 5.5°C (in July) to 15.5°C (in Jan). The instrument mast is 4 meters tall. Heat, water vapour, and carbon dioxide measurements are taken using the open-path eddy flux technique. Temperature, humidity, wind speed, wind direction, rainfall and net radiation are measured. Soil heat fluxes are measured and soil moisture content are collected.本数据集包含采用涡度协方差技术（eddy covariance）获取的地表-大气边界层间能量及物质交换通量塔观测数据。数据的质量控制与后处理流程严格参照Isaac等（2017）的方法，通过PyFluxPro（v3.4.21）软件完成处理。最终的间隙填充数据集涵盖生态系统净交换量（Net Ecosystem Exchange, NEE），并将其拆解为总初级生产力（Gross Primary Productivity, GPP）与生态系统呼吸（Ecosystem Respiration, ER）；该数据集依托Pastorello等（2020）提出的方法，通过ONEFlux软件生成。本数据集系FLUXNET Shuttle项目的产出成果之一。 博亚金旺都林地通量站坐落于西澳大利亚州珀斯近郊平杰利以西约12公里处。该站于2017年9月正式建成，由西澳大利亚大学负责运维管理。通量塔站点位于旺都林地范围内，周边区域以规模化大田农业种植为主。站点海拔约484米，邻近平杰利的澳大利亚气象局观测站记录的年平均降水量为446毫米。极端最高气温区间为15.3℃（7月）至31.9℃（1月），极端最低气温区间则为5.5℃（7月）至15.5℃（1月）。观测塔杆高4米，采用开路式涡度通量技术开展热量、水汽与二氧化碳通量观测。同步监测气温、相对湿度、风速、风向、降雨量与净辐射量，同时观测土壤热通量并采集土壤含水率数据。