Data from mooring deployed on Northeast Peak in the Georges Bank, Northeast Peak in 1995 (GB project)

<h3>GLOBEC Georges Bank Long-term Moored Array Component</h3> <h3>N.E. Peak Mooring Site<br /> 41 44' N, 66 32' W</h3> <p>The data reported here are for those data obtained by the N.E.Peak mooring deployment of Nov 1 1995 to Mar 30 1996.</p> <p>&nbsp;</p> <pre> <strong>Note:</strong> Sampling rates vary from instrument to instrument and depth to depth. <strong>Data Submitted by:</strong> Jim Irish Woods Hole Oceanographic Institution Woods Hole, MA 02543 phone: [phone] fax: [phone] e-mail: <a href=\"mailto:[e-mail]\">[e-mail]</a> 1. The nominal position of the mooring is the designed deployment site and actual deployments varied by about 0.5 nm around this position. 2. Sensor depths are nominal designed depths. In water sensors vary around this designed depth by about 1 m, variation larger at greater distance below buoy. 3. Temperatures are listed in the IPTS68 standard, rather than IPT90. 4. Salinity conversion from conductivity was done with PSS78 5. Sensor normalization was done with pre-cruise calibrations, and checked with post-cruise calibrations. 6. Only minor editing has been done to remove spikes from records. 7. No corrections have been made to fluorometer and transmissometer data to remove biological fouling induced drift. 8. No corrections have been made to salinity for drifts due to biological fouling. </pre> <p><em>updated 08/10/05; gfh</em></p><h3>GLOBEC乔治滩长期锚定阵列组件</h3> <h3>东北海峰锚泊站位<br />北纬41°44′，西经66°32′</h3> <p>本次发布的数据为1995年11月1日至1996年3月30日期间东北海峰锚泊系统获取的观测数据。</p> <p>&nbsp;</p> <pre> <strong>备注：</strong> 不同仪器及不同深度的采样速率存在差异。 <strong>数据提交者：</strong> 吉姆·爱尔兰（Jim Irish） 伍兹霍尔海洋研究所（Woods Hole Oceanographic Institution） 伍兹霍尔，马萨诸塞州 02543 电话：508 289 2732 传真：508 457 2195 电子邮箱：<a href="mailto:[e-mail]">[e-mail]</a> 1. 锚泊站的标称位置为预设布设点位，实际布设位置与该点位的偏差约为0.5海里（nm）。 2. 传感器深度为标称设计深度。水下传感器的实际安装深度与设计深度的偏差约为1米，且随着距离浮标深度的增加，偏差会进一步增大。 3. 本次温度数据采用1968年国际实用温标（IPTS68），而非1990年国际实用温标（IPTS90）。 4. 盐度由电导率转换而来，转换方法采用1978年实用盐标（PSS78）。 5. 传感器的归一化处理采用航前校准结果完成，并通过航后校准进行验证。 6. 仅对数据记录中的尖峰噪声进行了少量编辑剔除处理。 7. 未对荧光计与透射仪的观测数据进行校正，以消除生物附着导致的漂移误差。 8. 未针对生物附着导致的盐度漂移进行校正。 </pre> <p><em>更新于2005年8月10日；gfh</em></p>