WaterWatcher data

A measurement and development platform for collecting water quality data (the WaterWatcher) was developed. The platform includes sensors to measure turbidity, total dissolved solids (TDS), and water temperature as variables that are often collected to assess water quality. The design is extensible for research and monitoring purposes, and all design files are provided under open-source permissive licenses for further development. System design and operation are discussed for illustrative purposes. A block diagram indicates elements of mechanical, electrical, and software design for this system. The mechanical assembly used to house circuit boards and sensors is designed using 3D printing for rapid prototyping. The electronic circuit board acts as a carrier for an Arduino 32-bit microcontroller board and an associated cellular module along with a GPS for geolocation of water quality measurements. The cellular module permits data transfer for Internet of Things (IoT) functionality. System operation is set up using a command line interface (CLI) and C++ code that allows for calibration coefficients and human-readable transfer functions to be defined so that sensor voltages are related to physical quantities. Data are cached on a secure digital (SD) card for backup. The circuit was calibrated, and system operation assessed by deployment on an urban reservoir. Biogeochemical cycles were identified in the collected data using spectrogram and semivariogram analyses to validate system operation. As a system with hardware and software released under an open source license, the WaterWatcher platform reduces the time and effort required to build and deploy low-cost water quality measurement sensors and provides an example of the basic hardware design that can be used for measurements of water quality.<br>Dr. Nicholas Kinar &amp; Dr. Markus Brinkmann<br>@ University of SaskatchewanSaskatoon, Saskachewan, Canada