Impact of long-term water level draw-down on functional plant trait composition of northern peatlands@en

We measured the following vascular plant functional traits: plant height (cm), leaf size (LS, cm2), specific leaf area (SLA, cm2 g-1), leaf dry matter content (LDMC, mg g-1) and leaf moisture content (g g-1) from the most common species in each research unit. We measured the following Sphagnum traits: capitulum density (number of shoots cm-2), fascicle density (number cm-1), surface density (mg cm-3), capitulum dry mass (mg) and capitulum moisture content (cap_wc, g g-1). In addition, rate of net photosynthesis was measured at four light levels. The data was collected from Lakkasuo mire complex located in Southern Finland (61° 47' N; 24° 18' E). The study includes three sites called rich fen, poor fen, and bog. At each site two experimental units were established in 2000/2001: an undrained control unit and a Water level drawdown (WLD) unit that was surrounded by a 30 cm-deep ditches after a control year. Photosynthesis measurements were carried out during summer 2016, while other traits were sampled during August 2016. We measured vascular plant vegetative height (cm), leaf area (LA, cm2 leaf-1) with a leaf area scanner (LI-3000, LI-COR Inc.), leaf fresh mass and leaf dry mass after the sample was dried at 40 °C for at least 48h (mg leaf-1). Leaf dry matter content (LDMC mg g-1) was calculated from fresh and dry mass, while specific leaf area (SLA, cm2 g-1) was calculated from LA and dry mass. Leaf traits were measured from five replicate plants as an average of a sample of ten fully grown healthy leaves from each plant. Sphagnum moss traits were measured from five replicates of single-species samples. Each sample consisted of two parts: a volume-specific sample collected with a core (diameter 7 cm, area 38.5 cm2, height 3 cm) to maintain the natural density of the stand and an additional sample of ca. 10 individuals, with stems more than 5 cm at length. Before collecting the core in the field, the number of shoots was counted from a 4 × 4 cm square for capitulum density (cap_dens, number of shoots cm-2). The volume-specific sample was cleaned of litter and unwanted species before drying at 40 °C for at least 48h to determine the surface density (surf_dens, mg cm-3). The additional sample of ten moss individuals was divided into capitula and stems (4 cm below capitula). We counted the number of fascicles on the 4 cm stem segments (fasc_dens, number cm-1). […]