Physcial data from GLOBEC Georges Bank Long-term Moored Array Component on the Northeast Peak, Mar-Aug 1999

<h3>GLOBEC Georges Bank Long-term Moored Array Component</h3> <h3>N.E. Peak Mooring Site<br /> 41 44' N, 66 32' W</h3> <p>One deployment was made in 1999 at this site, Mar 12. 1999 to Aug 14 1999. (Dates reflect dates of data not deployment time)</p> <p>&nbsp;</p> <pre> <strong>Note:</strong> Sampling rates vary from instrument to instrument. <strong>Data Submitted by:</strong> Jim Irish Woods Hole Oceanographic Institution Woods Hole, MA 02543 phone: [phone] fax: [phone] e-mail: <a href=\"mailto:[e-mail]\">[e-mail]</a> 1. The nominal position of the mooring is the designed deployment site and actual deployments varied by about 0.5 nm around this position. 2. Sensor depths are nominal designed depths. In water sensors vary around this designed depth by about 1 m, variation larger at greater distance below buoy. 3. Temperatures are listed in the IPTS68 standard, rather than IPT90. 4. Salinity conversion from conductivity was done with PSS78 5. Sensor normalization was done with pre-cruise calibrations, and checked with post-cruise calibrations. 6. Only minor editing has been done to remove spikes from records. 7. No corrections have been made to fluorometer and transmissometer data to remove biological fouling induced drift. 8. No corrections have been made to salinity for drifts due to biological fouling. <em> updated 08/10/05; gfh</em></pre><h3>GLOBEC乔治滩长期锚定阵列组件（GLOBEC Georges Bank Long-term Moored Array Component）</h3> <h3>东北峰锚定站位（Mooring Site）<br /> 41°44′N，66°32′W</h3> <p>1999年3月12日至1999年8月14日在该站位完成一次锚系布放（注：此处标注日期为数据获取日期，而非实际布放作业时间）。</p> <p>&nbsp;</p> <pre> <strong>说明：</strong> 各仪器的采样速率存在差异。 <strong>数据提交者：</strong> 吉姆·艾尔利希（Jim Irish） 伍兹霍尔海洋研究所（Woods Hole Oceanographic Institution） 马萨诸塞州伍兹霍尔，02543 电话：508 289 2732 传真：508 457 2195 电子邮箱：[e-mail] 1. 锚系（Mooring）的标称位置为预设布放点位，实际布放位置会围绕该点位偏移约0.5海里。 2. 传感器安装深度为标称设计深度，水下传感器的实际安装深度会围绕该设计值波动约1米，且离浮标越远，深度偏差越大。 3. 温度数据采用IPTS68（国际实用温标1968）标准，而非IPTS90（国际实用温标1990）。 4. 盐度由电导率换算得到，换算方法遵循PSS78（实用盐标1978）标准。 5. 传感器的归一化校正基于航前校准完成，并通过航后校准进行验证。 6. 仅对记录中的尖峰噪声进行了少量编辑剔除。 7. 未对荧光计（Fluorometer）和透射仪（Transmissometer）的观测数据进行校正以去除生物附着引发的漂移。 8. 未针对生物附着引发的漂移对盐度数据进行校正。 <em>2005年8月10日更新；gfh</em> </pre>