Dataset Direct Download Service (WFS): Andelle Valley Hazard Zones of the PPRI

Area exposed to one or more hazards represented on the hazard map used for risk analysis of the RPP. The hazard map is the result of the study of hazards, the objective of which is to assess the intensity of each hazard at any point in the study area. The evaluation method is specific to each hazard type. It leads to the delimitation of a set of areas on the study perimeter constituting a zoning graduated according to the level of the hazard. The assignment of a hazard level at a given point in the territory takes into account the probability of occurrence of the dangerous phenomenon and its degree of intensity.For multi-random PPRNs, each zone is usually identified on the hazard map by a code for each hazard to which it is exposed. All hazard areas shown on the hazard map are included. Areas protected by protective structures must be represented (possibly in a specific way) as they are always considered to be subject to hazard (cases of breakage or inadequacy of the structure).The hazard zones may be classified as data compiled in so far as they result from a synthesis using several sources of calculated, modelled or observed hazard data. These source data are not covered by this class of objects but by another standard dealing with the knowledge of hazards.Some areas of the study perimeter are considered “zero or insignificant hazard zones”. These are the areas where the hazard has been studied and is nil. These areas are not included in the object class and do not have to be represented as hazard zones. However, in the case of natural RPPs, regulatory zoning may classify certain areas not exposed to hazard as prescribing areas (see definition of the PPR class).本数据集为用于RPP风险分析的灾害地图（hazard map）上标注的、受一种或多种灾害影响的区域。该灾害地图为灾害研究的成果，其研究目标为评估研究区域内任意点位的各类灾害强度。评估方法因灾害类型而异，其成果为在研究范围内划定一系列区域，形成按灾害等级分级的灾害分区。对研究区域内指定点位的灾害等级进行赋值时，需综合考量该危险现象的发生概率及其强度等级。针对多随机PPRNs，灾害地图上的每个分区通常会通过其受影响的各类灾害对应的编码进行标识。本数据集包含灾害地图上标注的全部灾害区域。防护设施所防护的区域必须予以标注（可采用特定方式），因为即便设置了防护设施，仍存在结构破损或防护能力不足的情况，此类区域仍会被认定为受灾害影响。此类灾害分区可归类为整合型数据，其来源于对多源计算、建模或观测得到的灾害数据的综合分析。此类源数据不属于本对象类别的覆盖范围，而是由另一项针对灾害认知的标准进行规范。研究范围内的部分区域被视为“零灾害或微灾害区域”，即经研究确认灾害强度为零的区域。此类区域不属于本对象类别的覆盖范围，无需作为灾害分区进行标注。但对于天然RPPs，监管分区可将部分未受灾害影响的区域划定为规定区域（详见PPR类别的定义）。