Fixed point plateaux measured by SMU within the MultiFixRad project.

The dataset contains measurement of fixed point plateux induced in the Ag, Au, Cu, Fe-C, Co-C and Pd-C cells created by SMU during the project MultiFixRad (see the community to which this deposit belongs). The data file "smu_plateaux_txt" contains one plateau for each fixed point. It is a semicolon delimited text file with four columns: Fixed point, a string, and either Ag, Au, Cu, Fe-C, Co-C and Pd-C. For instance, each row labelled "Ag" is a datapoint recorded from the Ag cell. Count, an index into each row for each fixed point. The counter is reset every time a new fixed point is started. Duration since a start (a point during the initial rising flank just after the furnace temperature has been increased to above the melting temperature). Signal, as measured by a nanovoltmeter, in mV. The data file "Chino SMU spectral data" contains measured spectral response for radiation thermometer used. The file follows the same pattern as the other datafile, except that there are only two data columns: The wavelength, in nm The Chino response in mV. The third file is a short code snippet to load the data into Matlab.本数据集涵盖了SMU在MultiFixRad项目中于Ag、Au、Cu、Fe-C、Co-C及Pd-C电池体系内诱导生成的固定点平台测量数据（详见该数据集所属的相关社区说明）。 数据文件"smu_plateaux_txt"为每个固定点对应一组平台数据。该文件为分号分隔的文本文件，共包含四列数据： 1. 固定点（Fixed point）：字符串类型，取值为Ag、Au、Cu、Fe-C、Co-C或Pd-C。例如，标签为"Ag"的每一行均为从Ag电池体系中记录的实测数据点。 2. 计数（Count）：每个固定点对应行的索引值，每当启动新的固定点测量时，该计数器将重置。 3. 起始时长（Duration since a start）：指炉温升高至熔点以上后，初始上升沿某一时刻至当前的时长。 4. 信号（Signal）：由纳伏表（nanovoltmeter）测得的电压值，单位为毫伏（mV）。 数据文件"Chino SMU spectral data"包含所用辐射温度计的实测光谱响应数据。该文件格式与前述数据文件一致，仅包含两列数据： 1. 波长（wavelength）：单位为纳米（nm） 2. Chino响应值（Chino response）：单位为毫伏（mV）。 第三个文件为用于将数据导入Matlab的简短代码片段。