UAV outputs and associated field measurement of the herbaceous of a Sahelian Rangeland during the wet season in Northern Senegal

This dataset contains UAV outputs (mosaic and digital surface model) and field measurement of vegetation (shapefile) that were made in northern Senegal.

Site gradient measurement

The data was collected on a plot of the Centre of Zootechnical Researches of Dahra / ISRA during 2020 rainy season (from July 19, 2020, to September 17, 2020). The average rainfall for the period 1981-2018 was ranging from 221 mm.y-1 to 468 mm. y-1. The vegetation in the field is a herbaceous savannah where Vachellia tortilis and Balanites aegyptiaca are the dominant trees.

Field measurement.

UAV flight plan

We used two different drones : Bluegrass and Anafi of Parrot. The Bluegrass of Parrot was used from 19/07/2020 to 04/08/2020. The Bluegrass flights were done at 60 meters of altitude, with a speed of 2 m s-1, and 90% of overlap rate between images, on a double grid of 100 m x 100 m. Anafi of Parrot was used for the rest of the season. The Anafi flights were done at 60 meters of altitude, with a speed of 2 m s-1, and 90% of overlap rate between images, on a double grid of 100 m x 100 m and the angle of inclination of the camera fixed at 80°. The flights have been done with PIX4D capture application at earlier in the day every two days. A total of 61 drone flights were conducted over the rainy season.

Herbaceous Biomass

Every two days , after drone flight, herbaceous measurements were carried out, in three plots of 1 m² distributed respectively under the crown of a tree, at the edge of the crown, and at a distance from the edge of the crown equal to the height of the tree. These plots were rotated among the trees in the field until all four azimuths of trees were covered.We collected Fresh mass and dry mass.

Image analysis.

The drone images taken for each day of collect, were analyzed in the software PIX4DMapper (Pix4D SA, Lausanne, Switzerland) by the Structure from Motion method. We used precisely the 3D mapping option of the software. Then for each flight we computed and exported an orthophotograph and a digital surface model.

Data organization

The data contains :

DSM that contains the surface model in tiff

Mosaic that the orthomosaic in tiff.

Data that contains the shapefile with the position and table with the field measurements