Research data supporting "Modeling stator versus magnet width effects in high-Tc superconducting dynamos"

Research data supporting [Modelling and measurements of stator vs magnet width effects in high-Tc superconducting dynamos]. AMSC_Jc_B_theta_T.txt: J_c(B, theta) data used in the H-formulation model, calculated by normalising experimental I_c(B, theta) by the cross-section of the modelled wire. Data was measured at 35, 53 and 83 K in magnetic fields up to 0.7 T from a short sample of AMSC 46 mm wide superconducting wire. The four columns in the data file relate to temperature [units of kelvin], magnitude of magnetic field B [units of tesla], magnetic field angle [units of degrees] and I_c/w [units of A/cm].

本研究数据支撑《高温超导发电机（high-Tc superconducting dynamos）中定子与磁体宽度影响的建模与测量》一文。数据文件AMSC_Jc_B_theta_T.txt包含H公式（H-formulation）模型中使用的J_c(B, theta)数据集，该数据集通过将实验测得的I_c(B, theta)按建模超导线材的横截面积进行归一化处理得到。实验采用宽度为46 mm的AMSC超导线材短样，在35 K、53 K与83 K温度、最高0.7 T的磁场环境中完成采集。该数据文件共包含四列数据，分别对应温度[单位：开尔文]、磁场强度B[单位：特斯拉]、磁场角度[单位：度]以及I_c/w[单位：A/cm]。