Design 3D CAD data of an oversized-sample 35 GHz EPR resonator with an elevated Q value

Supplemental data for the manuscript
“Design and performance of an oversized 35 GHz EPR resonator with an elevated Q value”

General information
The CAD dimensions match the dimension of the manufactured resonator/probehead.
Not depicted in the CAD file are the modulation coils (the modulation coil holders on the sides of the cavity block are shown) and the mechanical connection between the coupling screw on top flange of the resonator and the movable coupling piston at the bottom.

Autodesk Inventor files
The assembly of the whole resonator is stored as “Qband_CW_Probenkopf”.
All dependent subassemblies and parts can be found in the folder “Q_band_CW_resonator_Inventor”.

3D files for Open source software
The complete resonator is stored in the file “Qband_CW_Probenkopf.stl”.
Since in this file all resonator components are merged into a single unit and cannot be depicted on their own, all resonator components are also stored seperately as .obj-files in the folder “Qband_CW_Probenkopf_obj_format”.

学术论文《高Q值超大尺寸35 GHz电子顺磁共振（Electronic Paramagnetic Resonance, EPR）谐振器的设计与性能》的补充数据

一般说明
计算机辅助设计（Computer Aided Design, CAD）尺寸与已加工制备的谐振器/探测头尺寸完全一致。
CAD文件中未绘制调制线圈（仅展示了腔体块侧面的调制线圈支架），以及谐振器顶部法兰上的耦合螺杆与底部可移动耦合活塞之间的机械连接结构。

Autodesk Inventor 文件
整套谐振器的装配文件存储为“Qband_CW_Probenkopf”。
所有从属子组件与零件均存放于“Q_band_CW_resonator_Inventor”文件夹中。

开源软件可用3D文件
完整谐振器存储于“Qband_CW_Probenkopf.stl”文件中。由于该文件将所有谐振器组件合并为单个整体，无法单独展示各组件，因此所有谐振器组件也以单独的.obj文件形式存储于“Q_band_CW_Probenkopf_obj_format”文件夹内。