Compilation of Strike-Slip Fault Surface Displacement Data From Recent and Historical Earthquakes

This repository contains offset measurements on strike-slip faults from recent and historical earthquakes measured by hand and with image correlation. The data in this repository were compiled from published studies (see Table 1 and Table 2 for references) and represent 63 global earthquakes. Some of the original data were available in tabular format, but many of the datasets were transcribed from tables or graphs in PDFs. Thus, minor errors may exist resulting from data transcription. These data are used in: Reitman, N.G., Mueller, K.J. & Tucker,G.E. (2022) Surface slip variability on strike-slip faults. Earth Surface Processes and Landforms, 47(4), 908–935. https://doi.org/10.1002/esp.5294 Description of Data: single_eq_data.zip contains a pickle file for each dataset. Each file contains offset (m), distance along the fault or fault section (km), offset minimum (m), offset maximum (m), and offset uncertainty (m), if the values were available from the original publications. Naming convention is AuthorDate-Fault or Earthquake.pkl singleEQs_notsubset_withSheetName.csv is a file that contains the metadata for each dataset that is presented in Tables 1 and 2. It is included to make the data files easier to ingest in codes. single_eqs.ipynb is a computational notebook that reads and plots each dataset. It requires Numpy, Matplotlib, and Pandas, and has been tested in Python 3.11.5. Reitman2021_Table1.xlsx and Reitman2021_Table2.xlsx are the tables included in the original publication. Email [e-mail] or [e-mail] with questions.本数据集仓库收录了通过人工测量与图像相关法（image correlation）获取的近年及历史走滑断层（strike-slip faults）同震位移测量数据。本仓库数据整合自已发表研究（参考文献见表1、表2），涵盖全球63次地震。部分原始数据以表格格式公开，但多数数据集系从PDF文献的表格或图像中转录得到，因此可能存在因数据转录带来的微小误差。 本数据集用于以下研究： Reitman, N.G.、Mueller, K.J. 与 Tucker, G.E.（2022）《走滑断层地表滑动变异性》. 《地球表面过程与地貌》, 47(4), 908–935. https://doi.org/10.1002/esp.5294 数据集说明： `single_eq_data.zip` 包含各数据集对应的pickle文件（pickle file），每个文件存储位移量（单位：米）、断层/断层段沿走向距离（单位：千米）、位移最小值（米）、位移最大值（米）以及位移不确定度（米，若原始文献提供相关参数）。文件命名规则为：作者发表年份-断层/地震名称.pkl `singleEQs_notsubset_withSheetName.csv` 包含表1、表2中各数据集的元数据，旨在方便代码直接读取数据。 `single_eqs.ipynb` 为用于读取并可视化各数据集的计算笔记，依赖Numpy、Matplotlib与Pandas库，已在Python 3.11.5环境中完成测试。 `Reitman2021_Table1.xlsx` 与 `Reitman2021_Table2.xlsx` 为原发表论文所附附表。 如有疑问，请致信 [e-mail] 或 [e-mail]。