Wear in siding friction tests. Ring-on-ring contact. Sintered alumina ceramics (98%). Paraffin oil lubrication. Specim. sets #20-#21, #22-#23, #24-#25, #26-#27, #28-#29,#30 - #31. Run time: 0-4h. High frequency burst recording.

Wear in sliding friction tests in ring-on-ring contact. Sintered alumina ceramics (98%) in self-mated contact. Lubrication: paraffin oil. Sliding velocity: 0.2 m/s. Mean contact stress: 10 MPa. Test rig: PT-3 Tribometer. High frequency burst recording.Running time: 0 - 4h.Specimen sets:Specim. sets (# [upper, rotating] - #[lower, non-rotating]):#20-#21, #22-#23, #24-#25, #26-#27, #28-#29,#30 - #31. CZ_PRZYS.MAT - accelerometerMOM_TAR.MAT - friction torqueOBCI.MAT - normal force (load), signal feed from hydraulic load systemPR_OBR.MAT - rotational velocity, signal feed from motor driving the spindle via poly-V belt transmissionSI_MEMB.MAT - normal force (load), signal feed from sensor built into non-rotational specimen (lower) holderTACHO.MAT - rotational velocity, signal feed from tacho-generator coupled directly to spindle turning the rotational specimen (upper)TEMPER.MAT - lubricant temperature in bulk volumeTMP_PR.MAT - temperature in direct vicinity of frictional contact Each data sub-set in a batch contains metadata on sampling frequency, physical units, calibration function (raw data to physical units conversion). See below example, representative to all the data vectors:cz_si_memb - sampling frequency in channel 'SI_MEMB',jend_si_memb - physical unit in channel 'SI_MEMB',fun_si_memb - calibration function (digital raw data to physical unit conversin function) in channel 'SI_MEMB',The actual measured signal (raw digital data) is stored in vector 'si_memb',The prefixes in metadata strings (e.g. cz_, jedn_, fun_) are repeatable in every sub-set.