遇见数据集

1.88kW BLDC Sensorless FOC with Flux Observer

收藏
Mendeley Data2024-01-31 更新2024-06-29 收录
官方服务:

资源简介:

This dataset is on the study of Motor controllers, for which author has done numerous experiments.dataset is in support of my planned research paper shortly to be submitted to "IEEE Transactions on Power Electronics".In this paper and dataset, speed and the position estimation of BLDC is done using the sensorless vector control method i.e., Field Oriented control (FOC) and observer. The implementation method is the known method of vector control, with the addition of SMO or flux observer which gives the estimation of speed and the sensorless rotor position. The switching pattern of the 3-phase inverter is implemented using space vector modulation.DIfferences in this paper dataset can be seen as the author has included following , with analysis which can be drawn from seeing attached graphs -performance comparison using Sliding Mode Observer (SMO) and flux observerPWM switching frequency is varied 45 times from 20 kHz to 2 MHz , - will help decide MOSFETs switching frequency. (as in industries even 20kHz is used)Stability MarginsOpen Loop Control PerformanceTransfer Function CompensationClosed loop TuningRoot Locus of Uncompensated System and Compensated SystemBode Plot - magnitude and phasePole Zero Map of Uncompensated System and Compensated SystemUnit-Step Response of Uncompensated System and Compensated SystemNyquist plot of Uncompensated System and Compensated SystemNichols chart of Uncompensated System and Compensated SystemImpulse Response of Uncompensated System and Compensated SystemSinusoidal ExcitationCompensated System is after using SMO/Flux observer.All this is implemented on 32-bit Real-Time microcontroller. The pins usage not mentioned here are used for other General-Purpose-CAN,USB, RS485 etc.PFC is not included in this simulation as it is assumed that PF = 1.These brushless motors and controllers are used in many industries including medical e.g. in Positive Airway Pressure respirators,ventilator.This study comes in handy to decide when designing in practice for industries and also for academia purposes. The author has used these results in designing new 2-3 different complex models(incomplete), may be uploaded later.There is related dataset, where also 8-pole Y winding motor is used but of different specification - "200W BLDC Sensorless FOC - Sliding Mode vs Flux Observer" ,DOI: https://dx.doi.org/10.21227/v7s8-pk56

本数据集围绕电机控制器展开研究,作者已针对该主题开展了大量实验,用于支撑即将投稿至《IEEE电力电子学报》(IEEE Transactions on Power Electronics)的研究论文。 在该论文及配套数据集中,作者采用无传感器矢量控制方法——即磁场定向控制(Field Oriented Control, FOC)与观测器——完成了无刷直流电机(BLDC)的转速与位置估算。本次实现基于成熟的矢量控制方案,新增滑模观测器(Sliding Mode Observer, SMO)或磁链观测器以实现转速与无传感器转子位置的估算。三相逆变器的开关模式采用空间矢量调制实现。 本数据集的特色内容及可通过附带图表开展的分析如下:采用滑模观测器与磁链观测器的性能对比;将PWM开关频率在20 kHz至2 MHz范围内调整45次,该结果可辅助确定MOSFET的开关频率(工业场景中亦常采用20 kHz频段);稳定裕度分析;开环控制性能;传递函数补偿;闭环调谐;未补偿系统与补偿系统的根轨迹;幅频与相频伯德图(Bode Plot);未补偿系统与补偿系统的零极点分布图;未补偿系统与补偿系统的单位阶跃响应;未补偿系统与补偿系统的奈奎斯特图(Nyquist Plot);未补偿系统与补偿系统的尼科尔斯图(Nichols Chart);未补偿系统与补偿系统的冲激响应;正弦激励响应。注:此处提及的补偿系统指搭载滑模观测器/磁链观测器后的系统。 所有实验均基于32位实时微控制器完成。未在此处说明的引脚被用于通用CAN、USB、RS485等外设接口。 本仿真未包含功率因数校正(Power Factor Correction, PFC)模块,因假设功率因数PF=1。 此类无刷电机与控制器广泛应用于多个工业领域,包括医疗行业——例如持续气道正压通气(Positive Airway Pressure, PAP)呼吸器及呼吸机。 本研究可为工业界实际设计工作与学术研究提供参考。作者已将本次研究结果用于设计2至3种不同的复杂模型(尚未完成),后续可能上传相关内容。另有一篇相关数据集,采用8极Y形绕组电机但规格不同,标题为《200W BLDC无传感器FOC——滑模观测器与磁链观测器对比》,DOI:https://dx.doi.org/10.21227/v7s8-pk56

创建时间:
2024-01-31
二维码
社区交流群
二维码
科研交流群
商业服务