杂物电梯监督检验收费计算数据
收藏资源简介：
杂物电梯监督检验收费计算是根据电梯的具体情况，包括电梯的额定载重量、额定速度、层/站/门数等因素，来确定检验费用的金额。它能够为电梯使用单位提供合理的收费依据，为电梯检验机构提供方便准确的收费标准。1、数据采集：收集杂物电梯额定载重量、额定速度、电梯层/站/门数、检验种类等参数。2、数据处理：首先根据额定速度v≤1，vx=0；1＜v≤1.75，vx=0.1；1.75＜v≤2.5，vx=0.15；v＞2.5,vx=2确定额定速度系数。根据额定载重量t≤1000，tx=0;1000＜t≤2000，tx=0.1;t＞2000，tx=0.15确定额定载重量系数。检验种类系数，安装监检为2，改造监检和大修监检为1.5。是否进口系数，是为1.5，否为1。3、套用算法公式计算：杂物电梯监督检验收费实收金额=（收费标准*（1+额定载重量系数+额定速度系数）+（【层/站/门三个参数中的最大值】-5）*80）*检验种类*是否进口。其中，【层/站/门三个参数中的最大值】如果三个参数最大值小于5则按5算。
The supervision and inspection fee calculation for dumbwaiter elevators is determined based on specific elevator specifications, including factors such as rated load capacity, rated speed, and the number of floors, stations and doors. It provides a reasonable charging basis for elevator operators and a convenient and accurate charging standard for elevator inspection agencies. 1. Data Collection: Collect relevant parameters including the rated load capacity, rated speed, number of floors, stations and doors of the dumbwaiter elevator, as well as the inspection type. 2. Data Processing: First, the rated speed coefficient is determined based on the following rules: - If the rated speed v ≤ 1, then vx = 0; - If 1 < v ≤ 1.75, then vx = 0.1; - If 1.75 < v ≤ 2.5, then vx = 0.15; - If v > 2.5, then vx = 0.2. Next, the rated load coefficient is calculated as follows: - If the rated load t ≤ 1000, then tx = 0; - If 1000 < t ≤ 2000, then tx = 0.1; - If t > 2000, then tx = 0.15. For the inspection type coefficient: the supervision inspection during installation is assigned a value of 2, while supervision inspections for renovation and major overhaul are assigned a value of 1.5. For the import coefficient: a value of 1.5 is used if the elevator is imported, and 1 if it is not imported. 3. Algorithm Calculation: The actual collected supervision and inspection fee for dumbwaiter elevators is calculated using the following formula: Actual Fee = (Charging Standard × (1 + Rated Load Coefficient + Rated Speed Coefficient) + (max(floors, stations, doors) - 5) × 80) × Inspection Type Coefficient × Import Coefficient. Note: If the maximum value of the three parameters (floors, stations and doors) is less than 5, it shall be calculated as 5.
