3D printing of functional hydrogel devices for screenings of membrane permeability and selectivity

This dataset accompanies the article \"3D printing of functional hydrogel devices for screenings of membrane permeability and selectivity\" by Isabel Arias Ponce, Rahul Sujanani, Joshua D. Moon, Juan Manuel Urueña, Craig Hawker, and Rachel Segalman in ACS Applied Polymer Materials. The article demonstrates the fabrication of a 3D printed millifluidic device for ligand permeability and selectivity measurements towards water separations. This dataset contains FT-IR data for ligand functionalized and non-functionalized samples, conductivity data and salt concentration data for the 3D printed device and permeation cell membrane samples, salt permeability data for both monovalent and divalent salt species at varying ligand densities, salt selectivity data at varying ligand concentrations, and conductivity calibration curves for all probes and salt species used in this study., , , This README.txt file was generated on 2024-07-01 by ISABEL F ARIAS PONCE GENERAL INFORMATION Title of Dataset: 3D printing of functional hydrogel devices for screenings of membrane permeability and selectivity Author Information A. Principal Investigator Contact Information Name: Craig Hawker Institution: University of California, Santa Barbara Address: Materials Department, University of California Santa Barbara, Santa Barbara, California 93106-5050, United States; Department of Chemistry & Biochemistry, University of California Santa Barbara, Santa Barbara, California 93106-9510, United States; Materials Research Laboratory, University of California Santa Barbara, Santa Barbara, California 93106-5121, United States Email: [[e-mail]](mailto:[e-mail]) Name: Rachel Segalman Institution: University of California, Santa Barbara Address: Materials Department, University of California Santa Barbara, Santa Barbara, California 93106-5050, United States; Department ...,